Connect Systems

June 2, 2020

You can update your radio from whatever version you have to this version without having to go through any intermediate steps.

MAKE SURE YOU HAVE A CURRENT SOFTWARE LICENSE

1. Using the "Software Control License Register" utility from the Tool Section of the CPS to determine if you need to register your radio.

2. If you need to update the radio, send the file to [email protected] and you will get a return file.

3. Use the "Software Control License Apply" utility from the Tool Section of the CPS to register your radio if not already registered.

For details on this procedure, download the application note "Instructions for upgrading software License (PDF)" available to the left.

SAVE YOUR CODE PLUG

1. Load the code plug from your radio using your the CPS that you normally use for that version of the firmware currrently in your radio.

2. Save the code plug as you will need it later.

UPDATE THE FIRMWARE

This version properly allows you to use version 4.01.006. To use it, do the following:

1. Get the radio into programming mode by pressing the PTT and top button as you turn on the radio. The LED should now be blinking orange, red, green.

2. Load Bootloader D2.04 using Flashburn 3.00 if you do not already have it installed.

3. Turn off the radio.

4. Get the radio into programming mode by pressing the PTT and top button as you turn on the radio. The LED should now be blinking orange, red, green.

5. Load the:

(a)CS750(4000)_Subscriber_RCDB_M100100_Host_S4.00.06.bin firmware using Flashburn 3.00 if you have a CS750 or the (b)CS751(4000)_Subscriber_RCDB_M100100_Host_S4.00.06.bin firmware using Flashburn 3.00 if you have a CS751

6. Turn off the radio.

7. Get the radio into programming mode by pressing the PTT and top button as you turn on the radio. The LED should now be blinking orange, red, green.

8. Load the latest firmware available on our website.

9. Turn off the radio.

10. Turn on the radio.

UPDATE THE VOICE

1. Unzip the voice packet file

2. Reload the Voice Packets using the CPS

RESTORE YOUR CODE PLUG

1. Using the CPS Data Translate program in CPS version R4.01.008, update the code plug saved earlier.

2. Write it back to your radio.

For details on this procedure, download the application note "Instructions for upgrading the code plug (PDF)" available to the left.

IF THE RADIO IS BRICKED

If the radio is truely bricked, then you have one more step to do before you complete the above steps. Contact us if that happens to you.